Mi-T-M Propane Convection Heater Manual do Operador descarregar pdf (Página 12)

12 Propane Convection Heater Manual

THEORY OF OPERATION

Fuel Supply System Fuel is supplied under pressure from the fuel cylinder to the heater by the hose/

regulator assembly. The regulator maintains a constant ow of fuel to the heater.

System of Ignition As the fuel is sprayed into the combustion chamber, through a supply nozzle, the

Piezo ignitor ignites the ne mixture of fuel and air.

Automatic Control System If the ame should extinguish, the Automatic Control Valve shuts down the

heater.

WARNING: REVIEW AND UNDERSTAND ALL OF THE WARNINGS IN THE SAFETY INFORMATION

SECTION OF THIS MANUAL.

WARNING: DUE TO VERY HIGH SURFACE TEMPERATURES, IT IS IMPORTANT TO KEEP

CHILDREN, FURNITURE AND CLOTHING AWAY FROM THE HEATER. KEEP CONTROL AND

BURNER AREA FREE FROM DIRT AND DEBRIS.

WARNING: EXTREMELY HOT WHILE IN OPERATION. DO NOT TOUCH HEATER WHILE

OPERATING. KEEP CHILDREN, FURNITURE, CLOTHING, GASOLINE AND OTHER FLAMMABLE

LIQUIDS AND VAPORS AWAY FROM HEATER.

NOTE: Once the gas connection has been made, air may be trapped in the gas line. Before lighting the heater it will be neces-

sary to purge any air trapped in the line. Once this is done the heater will light and operate normally. Purging the gas line

will be necessary every time the gas cylinder is replaced.

PREPARING FOR OPERATION

1. Check the heater for possible shipping damage. If any is found, immediately notify your local dealer.

2. Follow all Safety Information in this manual.

LIGHTING INSTRUCTIONS (MH-0080-CM10)

1. Stop! Read all of the Safety Information provided with this heater

2. Turn valve on propane cylinder counterclockwise until fully open

3. Press in Control Knob and turn counterclockwise to LOW/IGN position

4. If burner does not ignite, turn Control Knob to OFF position and repeat the ignition procedure

5. Keep Control Knob pressed in for approximately 15 seconds before releasing.

6. If the ame goes out, wait 5 minutes, and repeat the ignition and lighting steps

7. After heater ignites, turn Control Knob to desired heat setting.

RELIGHTING INSTRUCTIONS

1. Rotate valve on cylinder clockwise to close it, and wait ve (5) minutes.

2. Relight following the LIGHTING INSTRUCTIONS.

SHUT-DOWN INSTRUCTIONS

1. Turn Control Knob to the OFF position

2. Rotate valve on cylinder clockwise to close it

LIGHTING INSTRUCTIONS (MH-0200-CM10)

WARNING: BEFORE LIGHTING HEATER, TURN MAIN BURNER VALVE TO LIGHT POSITION. READ

SAFETY WARNING: INFORMATION BEFORE STARTING THE HEATER.

1. Fully open the valve on the propane tank, and set burner valve to LIGHT position, then wait 15 seconds

before Step 2.

2. Depress the red button on the safety shut-off valve, admitting gas to the burner. Then push and release the

ignition button until the burner lights.

OPERATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Comentários a estes Manuais

Sem comentários

Mi-T-M Propane Convection Heater Manual do Operador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Aquecedores elétricos Mi-T-M Propane Convection Heater